Blog 1.0 Released!
Anybody who’d been reading this page during the last 10 minutes or so (before this entry appeared) might have noticed that a new download link had been added to the sidebar 🙂 Yes, Blog 1.0 is finally here for download <vbg> I finally managed to get the problems with archive creation sorted out and decided to do a release before I got too embroiled in something or other again …
The download is pretty hefty – almost 5MB and I did notice when I tested that I couldn’t download from Tripod but the mirror sites should be fine. I did test Nortiq and that worked and RazorSys should be OK too … The download is actually a self-extracting archive and once extracted you’ll be presented with a set of setup files. Run the Setup.Exe, answer the questions and you should have Blog all set up and ready to go. The directory where you installed Blog will also have a Blog.txt file which should answer most of your questions as to how to use Blog. Let me know if you have any problems or questions …
I do use Blog on a daily basis since Blog is what I use to create these entries but I’ve never installed and used Blog on a machine after doing a Setup install – so you might run into some problems … If you do, let me know …
No Responses to Blog 1.0 Released! ↓
Subscribe to comments with RSS
There are no comments yet... Get the ball rolling by filling out the form below.
Leave a response